Remington HH-70-SS User Manual download pdf (Page 8)

NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR

WHILE CONNECTED TO A POWER SOURCE

© 2013, Pinnacle Products International, Inc. Oil Fired Radiant Heater User’s Manual

Maintenance

Long Term Storage:

1. Unscrew the fuel cap.

2. Using an approved siphon, remove the

Kerosene or diesel.

3. Using a small amount of Kerosene or diesel,

rinse and swirl the fuel inside the fuel tank

NOTE: NEVER MIX WATER WITH FUEL. It will

cause rust inside the tank.

4. Empty the tank completely.

IMPORTANT: Never store leftover Kerosene

between seasons, using old fuel can

damage heater.

Store Heater in a dry, well ventilated area.

- Be sure that the storage area is free of dust

and corrosive vapors. Repack the heater

in the original packaging and keep user’s

manual in an easily accessible place.

Service:

DO NOT TAMPER WITH THE UNIT. HAVE AN

EXPERIENCED SERVICEMAN MAKE ANY

NECESSARY ADJUSTMENT OR REPAIRS.

We suggest following a maintenance schedule as

follows:

FUEL / FUEL TANK:

Flush tank every 200 hours of operation or as

needed. DO NOT ush with water, use fresh

Kerosene only.

SPARK PLUG:

Clean and re-gap every 600 hours of operation

or replace as needed. After removing the Spark

Plug, clean the terminals with a wire brush.

Re-gap the terminals to 0.140” (3.5mm).

(See Figure 7)

FAN BLADES:

The fan blades should be cleaned at least once

per heating season, depending on conditions.

Remove all accumulated dust and dirt with a

burst of condensed air. (See Figure 8)

7

TIP: Follow the long term storage

instructions to ush the tank.

Never service heater while it is

plugged in or hot!

WARNING

Figure 8

Figure 7

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments