Remington HH-70-SS User Manual download pdf (Page 11)

Problem Possible Cause Solution

Heater fires, but shuts down after a

short period of time.

1. Dirty Fuel Filter.

2. Nozzle Dirty.

3. Photocell Dirty.

4. Photocell not installed properly.

5. Photocell Defective .

6. Improper electrical connection

between Circuit Board and Photocell.

7. Cooling Fan is obstructed

1. Clean/replace Fuel Filter (Page 6).

2. Clean/replace Nozzle (Page 7).

3. Clean/replace Photocell (Page 7).

4. Adjust Photocell position.

5. Replace Photocell.

6. Check wiring connections (See

Wiring Diagrams, Page 10).

7. Check to be sure cooling fan is not

obstructed.

Heater will not operate, or motor runs

for short time.

1. No kerosene in fuel tank.

2. Corroded Spark Plug or incorrect

plug gap.

3. Dirty Fuel Filter.

4. Dirty Nozzle.

5. Moisture in Fuel/Fuel Tank.

6. Improper electrical connection

between Transformer and Circuit

Board.

7. Transformer Wires not connected to

Spark Plug.

8. Defective Transformer.

1. Fill tank with fresh kerosene.

2. Clean/replace Spark Plug (Page 7).

3. Clean/replace Fuel Filter (Page 6).

4. Clean/replace Nozzle (Page 7).

5. Rinse out fuel tank with clean fresh

kerosene (Page 6).

6. Inspect all electrical connections.

(See Wiring Diagrams, Page 10).

7. Re-attach Transformer wires to

Spark Plug.

8. Replace Transformer.

Fan does not operate when heater is

plugged in and Operating Switch is in

the “ON” position.

1. Broken electrical connection

between Circuit Board and motor.

2. Not enough amps available to power

heater.

1. Inspect all electrical connections on

Wiring Diagrams (Page 10).

2. Use a new extension cord or try

another electrical socket.

Heater does not turn on and the lamp

is not lit.

1. Temperature limit sensor has over-

heated.

2. No electrical power.

3. Fuse break down.

4. Improper electrical connection

between Temperature Limit Sensor

and Circuit Board.

1. Push Operating Switch to “OFF” and

allow heater to cool for 5 minutes.

Push Operating Switch back to “ON”.

2. Check power cord and extension

cord to insure of proper connection.

Test power supply.

3. Check/replace Fuse.

4. Inspect all electrical connections.

(See Wiring Diagrams, Page 10).

Trouble Shooting Guide

Poor combustion and / or soot

production.

1. Pump Pressure.

2. Poor fuel quality.

1. Be sure pump pressure is adjusted

correctly.

2. Be sure kerosene is not old or

contaminated.

Pinnacle Products International, Inc. Ultra-Portable Kerosene User’s Manual Page 11

Heater makes grinding noise.

1. Sound will stop after 3 seconds. If

grinding sound continues, add fuel

to tank.

1. Air in fuel pump.

Ultra-Portable Oil-

Fired Radiant Heater

NEVER LEAVE HEATER

UNATTENDED WHILE BURN-

ING, OR WHILE CONNECTED

TO A POWER SOURCE.

1 2 ... 6 7 8 9 10 11 12

Comments to this Manuals

No comments