Remington HH-600T-KFA User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
© 2014 Pinnacle Products International, Inc.
5
Kerosene Users Manual
Assembly (Continued)
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A POWER SOURCE
HH-600T-KFA
Wheel support frame Yes
Wheels and Axle Yes
Wheel Caps Yes
Front and Rear Handle Yes
Cord Wraps Yes
Handle Frame Yes
Screws, Nuts and Washers Yes
Cotter Pins and Bushings Yes
Bushings
Screws (S)
Front Handle
Handle Frame
Axle
Rear Handle
Figure 3: Hardware Components
Wheels
Nuts Cord Wraps
Wheel Support Frame
Cotter Pins
Bushings
Screws (L) Flat Washers (S) Flat Washers (L)
HH-600T-KFA
- Tools required: Medium phillips screw driver, open end or
adjustable wrench, needle nose pliers.
ASSEMBLING FRAME AND WHEELS
1. Slide axle through wheel support frame. Install wheel bushings,
flat washers (S) and wheel on axle.
NOTE: When installing wheels, tube valve should face out from
support frame (Figure 2).
2. Place flat washers (L) and cotter pins on axle ends and bend
cotter pins with long nose pliers to secure.
3. Place wheel cap on flat washers (L) and put wheel cap in flat
washers (L) end.
4. Place heater on wheel support frame. Make sure air inlet end
(rear) of heater is over wheels. Align the holes on fuel tank
flange. Insert
screws through handles (front and rear), fuel tank
flange, and wheel support frame as shown in Figure 3 and
attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
DO NOT OPERATE HEATER WITHOUT
SUPPORT FRAME FULLY ASSEMBLED
TO TANK.
CAUTION
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments