Remington HH-600T-KFA User Manual download pdf (Page 14)

© 2014 Pinnacle Products International, Inc.

14

Kerosene User’s Manual

NEVER LEAVE HEATER

UNATTENDED WHILE BURN-

ING OR WHILE CONNECTED

TO A POWER SOURCE

Troubleshooting

1. Wrong pump pressure

2. Dirty fuel filter

3. Dirt in nozzle

4. Dirty photocell lens

5. Photocell assembly not properly installed

(not seeing flame)

6. Bad electrical connection between photocell

and Main PCB assembly

7. Defective photocell

1. No fuel in tank

2. Wrong pump pressure

3. Carbon deposits on spark plug and/or

improper gap

4. Dirty fuel filter

5. Dirt in nozzle

6. Water in fuel tank

7. Bad electrical connection between ignitor

and Main PCB assembly

8. Ignitor Wire not attached to spark plug

9. Defective ignitor

1. Thermostat setting too low

2. Poor electrical connection between

motor

and Main PCB assembly

1. See Pump Pressure Adjustment, Page 10

2. See Fuel Filter, Page 10

3. See Nozzle, Page 9

4. Clean Photocell Lens, Page 9

5. Make sure photocell boot is properly seated in

bracket (See page 10)

6. Check electrical components (See Wiring

Diagrams, Page 11)

7. Replace Photocell, Page 10

1. Fill tank with kerosene

2. See Pump Pressure Adjustment, Page 10

3. See Spark Plug, Page 9

4. See Fuel Filter, Page 10

5. See Nozzle, Page 9

6. Flush fuel

tank with clean kerosene, page 7

7. Check electrical connections (See Wiring

Diagrams, Page 11)

8. Attach ignitor wire

to spark plug (See Spark Plug,

Page 9)

9. Replace ignitor

1. Adjust thermostat to a higher setting

2. Check electrical connections (See Wiring

Diagrams, Page 11)

E1

E1

Fan does not turn when

heater is plugged in.

E1 or E2

E3

Heater will not ignite, but

motor runs for a short period

of time (Lamp is flickering)

1. Switch Failure

2. Short Circuit

1. Replace Switch

2. Check Wiring and connection

Symptom Possible Cause(s) Solution

1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments