Remington 498 User Manual download pdf (Page 20)

114915

D. REMOVING FIRING PIN

1. Remove plug from end of tool. Do this by pressing plug in and turning it 90°.

This will release the plug from the tool body.

2. Remove the two springs within the cylinder at rear of tool body.

3. Use needle-nosed pliers to grasp nut at rear of ﬁring pin assembly. Pull ﬁring

pin assembly and sear assembly from tool body.

4. Remove push pin from inside tool body. Do this by tilting rear of tool down. Push

pin will fall out.

5. Remove ﬁring pin assembly from sear assembly.

E. REMOVING TRIGGER ASSEMBLY

1. Remove trigger pin from tool body (see Figure 8). Note: End of trigger pin is

threaded. Unscrew threaded portion of pin, then pull pin from tool body.

2. Remove trigger assembly from rear of tool body.

Figure 7 - Removing Plug and Springs to Access Firing Pin

F. REMOVING LINER FROM TOOL BODY

Note: You must remove trigger assembly before removing liner.

1. Remove two screws just under liner at front of tool body.

2. Grasp liner and hold tool vertically with liner pointing down.

3. Remove liner from tool body.

4. Remove two springs and two ball bearings at rear of liner.

Figure 8 - Removing Trigger Pin and Trigger Assembly

Tool Disassembly and

Assembly

Trigger Pin

Trigger

Assembly

Ball Bearing

Liner

Spring

Screws

Plug

Firing Pin

and Sear

Assembly

Springs

Figure 9 - Removing Liner From Tool Body

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 87 88

No comments

Remington 498 User Manual Page 20