Remington 494 User Manual download pdf (Page 6)

106084

TOO HARD

Point

flattens

482-29

482-25

TOO BRITTLE

Surface

shatters

482-30

TOO SOFT

Sinks in

with

average

hammer

blow

482-28

G 018

G 018G 018

G 018

Safety Precautions

1. ALWAYS know the thickness and type of base material into which you are fastening. NEVER

GUESS. Test the base material by using the Center Punch Test. The Center Punch Test is

performed by using a hammer to test drive the particular power fastener to be used into the

material. If the point penetrates easily, the material is too soft. If the point becomes blunt, the

material is too hard. If the material fractures, cracks or shatters, the material is too brittle. Test

fastenings can be made if the material shows a clear fastener impression and the fastener point

is not blunted. ALWAYS start with the lowest power load (Gray-Level 1) and proceeding with

the order shown in the lower right-hand figure above. Always wear approved goggles.

KNOW YOUR FASTENING BASE MATERIAL

482-26

7. An operator taking medication should take extra precautions while handling the tool. NEVER

drink alcoholic beverages or take medications which impair your vision, balance or judgement

before using a powder actuated tool.

CENTER

PUNCH TEST

482-27

Start

GRAY

GREEN

YELLOW

BROWN

482-31

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Remington 494 User Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Remington 494