Remington R300 User Manual download pdf (Page 13)

106088

FASTENING INTO CONCRETE

The proper power fastener length can be determined by

adding the thickness of the material to be fastened and the

amount of fastener that will actually penetrate the concrete.

The concrete must be three times as thick as the intended

fastener penetration. In most cases, penetration should be

approximately 1" to 1

/4" into the base concrete material.

482-85

Wood or Non-Metals

To Concrete

482-79

Wood or Non-Metals

To Steel

Selecting Power Fasteners

and Power Loads

482-66

RIGHT

Flush With Surface

OVERDRIVEN POWER FASTENERS

AND PISTON

An overdriven power fastener results when too strong of a

power load is used causing the piston to extend past the

muzzle. Move to the next lightest power load. Repeated

overdrive will damage your tool. By avoiding overdrive, you

can extend the life of your tool considerably and avoid costly

repairs.

NOTE: NEVER fire the tool without a power fastener. This can

damage the tool and/or cause possible injury to the operator.

IMPORTANT: DO NOT use power fasteners longer than 2

/2"

without the use of the accessory muzzle cap, part number

075961.

Piston Extended

Out of Muzzle

POWER LOADS

Always start with the lowest power level (gray-level 1). If the

first test fastener does not penetrate to the desired depth,

move to the next highest power level (brown-level 2). Increase

until a proper fastening is made.

IMPORTANT: Damage to the tool will result if the above

instructions are not followed (see illustrations to right and

lower right).

FASTENING INTO STEEL

The proper fastener length can be determined by adding the

thickness of the material to be fastened and the thickness of

the steel. The point of the power fastener must go completely

through the steel.

OVERDRIVE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comments to this Manuals

No comments

Remington R300 User Manual Page 13

Comments to this Manuals

Related products and manuals for Power screwdrivers Remington R300