Remington R300 Operations Instructions download pdf (Page 7)

119586

3. NEVER make fastenings in spalled or cracked areas.

2. NEVER attempt to drive power fasteners into very hard or

brittle materials including, but not limited to cast iron, glass,

tile, stone, brick, or hardened steel. Materials of this type

tend to shatter and create hazard from ﬂying particles.

NEVER drive power fasteners into thin or easily penetrated

material unless it is backed by concrete or steel. When in

doubt, such as when base material is concealed, conduct

a Center Punch Test (See page 6). Check continually to

avoid fastening into unsuitable material, especially in older

buildings.

5. DO NOT fasten through or within 1/2" of predrilled or pre-

punched holes.

Safety Precautions

CAST IRON GLASS

TILE

BRICK

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Remington R300 Operations Instructions Page 7