Remington R300 Operations Instructions download pdf (Page 21)

119586

IMPORTANT

• Recommended for use with Remington

power loads and

power fasteners.

• If power fastener goes below the top surface of the board, use

penetrating control disc (see illustration below) or washered

SPW-type power fasteners.

• Operators and bystanders must ALWAYS wear goggles and

ear protection which meet or exceed the accepted standards

for adequate protection in your country. In the USA, refer to

ANSI standards. In Canada, refer to CSA standards.

* Use power fastener with penetration control disc, part

number 015549.

Power load listings are recommendations only. If you are in

doubt, try a test fastening using the next lightest power load.

Power fasteners and power loads are available in blister packs

of 25 and cartons of 100.

Application Chart

Load Color Code

Stock Level Load Case

Number Number Strength Body Head

A22C1 1 light brass Gray

A22C2 2 medium brass Brown

A22C3 3 heavy brass Green

A22C4 4 extra heavy brass Yellow

.22 CALIBER Type A, neck-down crimp loads for powder

actuated tools

IMPORTANT

This tool is designed to use .22 caliber neck-down crimped

loads, power levels 1 (gray) through 4 (yellow).

5/8"

Straight Wadded

Power Load

Neck-Down Crimped

Power Load

CAUTION: Do not use any load other

than the .22 caliber neck-down crimped load.

Other types of loads will cause load-ejection

problems.

1 2 ... 16 17 18 19 20 21 22 23 24

No comments

Remington R300 Operations Instructions Page 21