Remington R300 Operations Instructions download pdf (Page 19)

19

119586

PROBLEM

Piston hangs

out of muzzle.

Overdriven fas-

tener.

Piston jammed.

Expended load

will not extract.

Reduction or

loss of power

Tool does not

completely de-

press.

POSSIBLE

CAUSE

Tool overdriven.

Piston not properly

assembled in rela-

tion to barrel screw.

Broken piston.

Excessive power.

Overdriving of fas-

tener (see above).

Dirty or damaged

chamber.

Broken ejector.

Piston not returning

to full rear position.

Worn piston ring or

broken piston.

Misassembled or

damaged breech

and ﬁring pin parts.

REMEDY

Tap piston on a hard

surface until piston is

pushed back into the

muzzle (see Overdriven

Fastener, below).

Remove barrel assem-

bly. Follow instructions

for barrel replacement

(see page 18). Replace

all damaged or missing

parts.

Replace barrel assem-

bly or take tool to your

distributor.

Change either to next

lower powder load or next

longer length fastener.

Remove barrel assem-

bly. Follow instructions

for barrel replacement

(see page 18). Replace

other parts if damaged.

Clean chamber. If loads

will not chamber with

slip-ﬁt or extraction dif-

ﬁculties continue, take

tool to your distributor.

Replace barrel assem-

bly or take tool to your

distributor.

Barrel must be snapped

to the full extended posi-

tion to properly position

piston against breech.

Replace barrel assem-

bly or take tool to your

distributor.

Remove breech and

check all parts for correct

ﬁt assembly.

Troubleshooting Guide

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments