Remington R300 Operations Instructions download pdf (Page 18)

119586

3. To assemble, push piston

(E) all the way into barrel

(B) using a screwdriver (G).

Slide the barrel assembly

(B) into the receiver (D).

Turn barrel (B) to line up

tang slot (F) with tang (C).

Insert tang (C) into tang slot

(F). Firmly tighten knurled

tang nut (A).

1. U

nscrew knurled tang nut

(A). Slide barrel assembly

(B) out and remove tang (C),

then remove barrel assem-

bly (B) from receiver (D).

WARNING: NEVER disassemble, replace barrel, clean,

or assemble a powder actuated tool while it is loaded.

Barrel Replacement

2. If tool has been overdriven, tap piston (E) on a hard surface

until the piston is pushed back into the muzzle. Inspect the

barrel assembly (B) and replace if damaged.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Remington R300 Operations Instructions Page 18