Remington R300 Operations Instructions download pdf (Page 16)

119586

CARE OF YOUR R300

Clean your R300 after each day’s use. Clean chamber with

accessory wire brush, part number 056485 (Not included with

tool). Apply good quality penetrating lubricant spray (such as

WD-40) sparingly and wipe dry.

NOTE: The labor regulations of many states require that the

operator of this tool on a job site be thoroughly trained and certi-

ﬁed for competence prior to operating this tool. For certiﬁcation

procedures, call: Technical Services Department, 1-800-858-

8501 (English only) or visit www.desatech.com.

PISTON OVERDRIVE

If the tool does not open after ﬁring and the piston is 1/2 inch or

more out of the muzzle:

1. Strike muzzle end of R300 against hard surface to force

piston back into muzzle.

2. Eject the power load (See step 8 of Operation).

OVERDRIVE

Operation

WATER

9. Should the tool fail to ﬁre, hold the muzzle ﬁrmly against

the work surface for 30 seconds. Release the trigger and

remove pressure on the tool while holding the muzzle

against the work surface. Again press the tool ﬁrmly against

the work surface and pull the trigger. If the tool still fails to

ﬁre, hold the tool ﬁrmly against the work surface for another

30 seconds before unloading and carefully discarding the

misﬁred power load into water or oil.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Remington R300 Operations Instructions Page 16