Remington 493 Operations Instructions download pdf (Page 3)

103500

Warning: Safety Precautions

IMPORTANT: Read these operating instructions carefully and com-

pletely before trying to operate or service this tool. Improper use of

this tool can cause serious injury or death from firing fastener into

body or from flying debris. We expressly disclaim any liability for any

injury to persons or damage to property which result from your failure

to take the precautions contained in this manual.

WARNING: This tool is designed only for use by qualified operators.

Qualification is obtained through a thorough understanding of the Safety

Warnings and operating instructions as defined in this operating manual.

NOTE: Your local labor regulations may require that the operator of this tool

on a job site be thoroughly trained and certified for competence prior to

operating this tool. For certification procedures, call: 1-800-626-2237

(U.S.A.) or 1-905-826-8010 (Canada).

1. Always handle the tool as if it were loaded. Before starting work, check that the

tool is unloaded and the muzzle is clear. Never load a tool unless it is going to

be used.

2. Always inspect to make sure the tool is working properly. If the tool does not

work properly, remove from service and tag “DEFECTIVE.” Do not use the tool

again until it has been properly repaired.

DEFECTIVE

BEFORE USING

3. Operators and bystanders must wear goggles and ear protection which meet

or exceed the accepted standards for adequate protection in your country. In

the U.S.A., refer to ANSI standards. In Canada, refer to CSA standards.

1 2 3 4 5 6 7 8 ... 27 28

No comments

Remington 493 Operations Instructions Page 3