Remington HT4022A Owner's Manual download pdf (Page 10)

 

118036





Use the trimmer properly. Always wear eye

protection, rubber gloves, and substantial

foot wear while using the trimmer (see

Figure 3-9). Always maintain proper foot-

ing and balance. Never overreach when

using trimmer. Before starting the trimmer,

hold the unit with both hands on the grip

areas. Make sure that the cutter blade is

not touching anything.

Always keep the extension cord behind

the trimmer when in use. Do not drape

the cord over the hedge where it may be

cut by the blades (see Figure 3-10).

Use smooth steady sweeping motions to

trim new growth (see Figure 3-11). Do

not try to cut too much at one time. is

can cause the trimmer to slow down or get

jammed, reducing the cutting eﬃciency.

Do not force the trimmer through dense

growth. A slight back and forth sawing

action may ease the cutting of larger, more

dense growth. If the trimmer begins to slow

down, reduce the rate of speed at which

you are trying to cut.

If the trimmer becomes jammed, immedi-

ately turn trimmer oﬀ. Disconnect trimmer

from the power supply and remove the

jammed debris from the cutter blades.

Do not try to cut branches larger than

3/4 inch in diameter.

For best results, trim the sides of hedges

with an upward sweeping motion (see Fig-

ure 3-12). Cut from the bottom and work

your way up. is will keep cut material

from falling into areas not yet cut.

Trim the hedges so that the top is slightly

narrower than the bottom.

To trim extremely level hedges, use a string

stretched along the length of the hedge as

a guide (See Figure 3-13).

Figure 3-9: Proper clothing, stance and grip

Figure 3-10: Protecting extension cord

Figure 3-11: Trimming new growth

Figure 3-12: Trimming sides of hedges

Figure 3-13: Using string to make level cuts

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comments to this Manuals

No comments