Remington 104316-01 Owner's Manual download pdf (Page 7)

7

097017

OWNER’S MANUAL

PUSH

TO

SHARPEN

INSTALLING AUTOMATIC

CHAIN SHARPENER

(Fast Sharp Models Only)

1. Screw automatic chain sharpener into

threaded hole.

2. Continue turning automatic chain

sharpener until you hear ﬁve (5) clicks.

Automatic

Chain

Sharpener

Figure 5 - Automatic Chain Sharpener

(Fast Sharp Models Only)

ASSEMBLY

Continued

Note:

For pre assembled models, the saw

chain tension is properly set at factory. A

new chain will stretch. Check new chain

after first few minutes of operation. Allow

chain to cool down. Follow steps below to

readjust saw chain tension.

1. Before adjusting chain, make sure guide

bar nuts are only ﬁnger tight (see Figure

3, page 6). Also make sure adjusting

block is in oval adjusting hole on guide

bar (see Figures 3 and 4, page 6).

2. Turn adjusting screw clockwise until

all slack is out of chain (see Figure 6).

Note:

There should be no gap between

side links of chain and bottom of guide

bar (see Figure 7).

3. Wearing protective gloves, move chain

around guide bar. Chain should move

freely. If chain does not move freely,

loosen chain by turning adjusting screw

counterclockwise.

4. After chain tension is correct, tighten

guide bar nuts ﬁrmly. If not, guide bar

will move and loosen chain tension.

This will increase the risk of kickback.

This can also damage saw.

Note:

A new

chain will stretch. Check new chain

after ﬁrst few minutes of operation.

Allow chain to cool down. Readjust

chain tension.

SAW CHAIN

TENSION

ADJUSTMENT

WARNING: Unplug chain saw

from power source before adjust-

ing saw chain tension.

WARNING: Cutting edges on

chain are sharp. Use protective

gloves when handling chain.

WARNING: Maintain proper

chain tension always. A loose

chain will increase the risk of

kickback. A loose chain may jump

out of guide bar groove. This may

injure operator and damage

chain. A loose chain will cause

chain, guide bar, and sprocket to

wear rapidly.

Figure 6 - Turning Adjusting Screw

Guide Bar

Correct

Tension

Guide Bar

Gap

Incorrect

Tension

Guide Bar

Nuts

Figure 7 - Saw Chain Adjustment

1. Remove oil cap.

2. Fill oil tank with SAE #30 motor oil.

Note:

For temperatures below 30°F, use

SAE #10 oil. For temperatures above

75°F, use SAE #40 oil.

3. Replace oil cap at once. Tighten oil cap

ﬁrmly for good seal. This will avoid oil

seepage from tank.

4. Wipe off excess oil.

Note:

It is normal for oil to seep when saw

is not in use. Empty oil tank after each use to

prevent seepage.

FILLING OIL TANK

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments