Remington 104316-01 Owner's Manual download pdf (Page 15)

15

097017

OWNER’S MANUAL

TROUBLESHOOTING

WARNING: Unplug chain saw from power source before servicing.

Severe injury or death could occur from electrical shock or body contact

with moving chain.

OBSERVED FAULT

Saw runs, but does not cut.

Saw does not cut unless heavily forced.

Cutting produces only sawdust with few

large chips.

Saw runs slow. Saw stalls easily.

Motor of saw does not run when you squeeze

trigger.

Motor of saw runs, but chain does not move.

Chain does not get oil.

Chain comes off guide bar.

Saw smokes.

Saw leaks oil.

POSSIBLE CAUSE

Chain assembled backwards on guide bar

Chain is dull

Low power supply voltage

1. Switch lockout not pressed in to release

trigger

2. Extension cord connections loose

3. Open line fuse or circuit breaker

4. Bad motor brushes

5. Open wiring circuit on saw

Gear train failure

1. Clogged oil slot in guide bar

2. Oil is too thick

1. Chain is loose

2. Guide bar and chain not assembled right

Saw damaged. Do not use saw.

Oil cap is not secure.

REMEDY

See Assembly, page 6

See Sharpening Saw Chain, page 13 (non-

Fast Sharp model) or page 14 (Fast Sharp

model)

Extension cord wire size too small. See

Extension Cords, page 8

1. Press in switch lockout before squeez-

ing trigger

2. Check cord connections

3. Check line fuse or circuit breaker

4. See authorized service center

5. See authorized service center

See authorized service center

1. Remove guide bar and clean oil slot

2. Use correct weight of oil. See Filling Oil

Tank, page 7

1. Tighten chain. See Saw Chain Tension

Adjustment, page 7

2. See Assembly, page 6

See authorized service center

Tighten oil cap. Note: Empty oil tank when

not in use.

TECHNICAL

SERVICE

You may have further questions about as-

sembling, operating, or maintaining this saw.

If so, contact DESA International’s Techni-

cal Service Department at 1-800-323-5190.

SERVICE

PUBLICATIONS

You can buy a service manual from address

listed on back page of this manual. Send a check

for $5.00 payable to DESA International.

You can receive an illustrated parts list free

of charge. Send a self-addressed stamped

envelope to address on back page of this

manual.

When writing, include model number and

serial number of saw. You will ﬁnd these

numbers on saw motor housing decal.

STORAGE

If storing saw for more than 30 days, follow

steps below.

1. Drain oil tank.

2. Remove and clean guide bar and chain.

Clean guide bar and chain by soaking

in petroleum based solvent or mild soap

and water mixture.

3. Dry guide bar and chain.

4. Place chain in container ﬁlled with oil.

This will prevent rust.

5. Wipe a thin coating of oil over surface

of guide bar.

6. Wipe off outside of saw body. Do this

with soft cloth dampened with a mild

soap and water mixture.

7. Store chain saw

• in a high or locked place, out of

children’s reach

• in a dry place

• in a carrying case or with scabbard

over guide bar

1 2 ... 10 11 12 13 14 15 16

Comments to this Manuals

No comments