Remington 100271-01 Owner's Manual download pdf (Page 16)

14

102891

ELECTRIC CHAIN SAW

®

Replacing Saw Chain

Replace chain when cutters are too worn to

sharpen or when chain breaks. Only use

replacement chain noted in this manual. Al-

ways include new drive sprocket when re-

placing chain. This will maintain proper driv-

ing of chain.

Note:

For proper chain and

drive sprocket, see Replacement Parts.

STORAGE

If storing saw for more than 30 days, follow

steps below.

1. Drain oil tank.

2. Remove and clean guide bar and chain.

Clean guide bar and chain by soaking

in petroleum based solvent or mild soap

and water mixture.

3. Dry guide bar and chain.

4. Place chain in container ﬁlled with oil.

This will prevent rust.

5. Wipe a thin coating of oil over surface

of guide bar.

6. Wipe off outside of saw body. Do this

with soft cloth dampened with a mild

soap and water mixture.

7. Store chain saw

• in a high or locked place, out of

children’s reach

• in a dry place

• in a carrying case or with scabbard

over guide bar

REPLACEMENT

PARTS

WARNING: Use only replace-

ment parts described in this

manual. Use of other parts could

damage saw or injure operator.

Purchase these parts from your local dealer.

Part Number Description

097570-01 Guide bar, 350 mm

091374-02S Chain, 350 mm

107713-01 Drive sprocket

CLEANING AND

MAINTENANCE

Continued

Filing Cutter Depth Gauges

The cutter depth gauge clearance is reduced

as cutters are sharpened. After every second

or third sharpening, reset cutter depth gauges.

1. Place depth gauge tool ﬁrmly across top

of two cutters. Make sure depth gauge

enters slot in depth gauge tool (see Fig-

ure 22).

2. Use medium ﬂat ﬁle. File depth gauge

level with depth gauge tool.

3. Remove depth gauge tool. With ﬂat ﬁle,

round off front corner of cutter depth

gauge (see Figure 23).

After several hand ﬁlings, have authorized

service center or sharpening service machine

sharpen chain. This will insure even ﬁling.

RECYCLING

In the event it is not practical to repair your

chain saw, be sure to follow local and coun-

try codes for recycling plastic and metallic

materials when disposing of the unit.

Figure 22 - Depth Gauge Tool On Chain

Figure 23 - Round Off Front Corner Of

Depth Gauge

Front Corner

Flat File

Depth

Gauge

Tool

Depth

Gauge

Depth

Gauge

Slot

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 73 74

Comments to this Manuals

No comments