Remington 100089-06 Owner's Manual download pdf (Page 30)

CLEANING AND

MAINTENANCE

Continued

9. Gently push on sharpener knob. Saw must be running for chain m sharpen.

Note: Sparks appearing shows sharpener is working (see Figure 25). If no sparks

appear, continue to adjust sharpener one click at a time. After each click, press

sharpener knob until light flow of sparks appears.

STORAGE

Figure 25 - Sharpening Fast Sharp Chain

After several sharpenings, you must turn sharpener knob more to bring stone into

position•

Replacing Saw Chain

Replace chain whencutters are too worn to sharpen or when chain breaks. Only use

replacement chain noted in this manual. Always include new drive sprocket when

replacing chain. This will maintain proper driving of chain. Note: For proper chain

and drive sprocket, see Replacement Parts and Accessories, page 28.

If storing saw for more than 30 days, follow steps below.

1. Drain oil tank.

2. Remove and clean guide bar and chain. Clean guide bar and chain by soaking in

petroleum based solvent or mild soup and water mixture.

3. Dry guide ba[ and chain:

4. Place chain in container filled with oil. This will prevent rust.

5. Wipe a thin coating of oil over surface of guide bar.

6. Wipe off outside of saw body. Do this with soft cloth dampened with a mild

soap and water mixture.

7. Store chain saw

• in a high or locked place, out of children's reach

• in a dry place

• in a ca'Tying case or with scabbard over guide bar

1 2 ... 25 26 27 28 29 30 31 32 33 34

No comments

Remington 100089-06 Owner's Manual Page 30