Remington LNT-3 12-inch FR User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
100583
ELECTRIC CHAIN SAW
®
OPERATING CHAIN
SAW
WARNINGICON G 001
WARNING: Read and under-
stand this owners manual before
operating this saw. Make certain
you read and understand all Safety
Warnings. Improper use of this
chain saw can cause severe in-
jury or death from re, electrical
shock, or body contact with mov-
ing chain, or falling wood.
EXTENSION CORDS
Use proper extension cord with this chain
saw. Use only extension cords marked for
outdoor use. Use an extension cord no less
than 1.5 mm
2
(14SWG) at distances up to 30
meters (100 feet). The cord must be marked
with suffix W following the cord type mark-
ing. Example: SJTW
Use an extension cord heavy enough to
carry the current your saw will draw. An
undersized cord will cause a voltage drop at
the saw, loss of power, and overheating.
Keep cord away from cutting area. Make
sure cord does not catch on branches or logs
during cutting. Inspect cords often. Replace
damaged cords.
The extension cord may come undone from
the power cord during use. To avoid this,
make a knot with the two cords as shown in
Figure 7 below.
Extension
Cord
Chain Saw
Power Cord
Figure 7 - Tying Extension Cord and Power
Cord in Knot
SAW CHAIN
TENSION
ADJUSTMENT
WARNINGICON G 001
WARNING: Unplug chain saw
from power source before adjust-
ing saw chain tension.
WARNINGICON G 001
WARNING: Cutting edges on
chain are sharp. Use protective
gloves when handling chain.
WARNINGICON G 001
WARNING: Maintain proper
chain tension always. A loose
chain will increase the risk of
kickback. A loose chain may jump
out of guide bar groove. This may
injure operator and damage
chain. A loose chain will cause
chain, guide bar, and sprocket to
wear rapidly.
Note:
For pre assembled models, the saw
chain tension is properly set at factory. A
new chain will stretch. Check new chain
after first few minutes of operation. Allow
chain to cool down. Follow steps below to
readjust saw chain tension.
1. Before adjusting chain, make sure guide
bar nuts are only finger tight (see Figure
3, page 7). Also make sure adjusting
block is in oval adjusting hole on guide
bar (see Figures 3 and 4, page 7).
2. Turn adjusting screw clockwise until
all slack is out of chain (see Figure 5).
Note:
There should be no gap between
side links of chain and bottom of guide
bar (see Figure 6)
3. Wearing protective gloves, move chain
around guide bar. Chain should move
freely. If chain does not move freely,
loosen chain by turning adjusting screw
counterclockwise.
Guide Bar
Nuts
Guide Bar
Correct
Tension
Incorrect Tension
Figure 5 - Turning Adjusting Screw
Figure 6 - Saw Chain Adjustment
Guide Bar
Gap
4. After chain tension is correct, tighten
guide bar nuts firmly. If not, guide bar
will move and loosen chain tension.
This will increase the risk of kickback.
This can also damage saw.
Note:
A new
chain will stretch. Check new chain
after first few minutes of operation.
Allow chain to cool down. Readjust
chain tension.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments