Remington RM4625 Operator's Manual download pdf (Page 8)

STARTING AND STOPPING

STARTING INSTRUCTIONS

1. Mix gasoline with oil. Refer to Oil and Fuel Mixing Instructions.

2. Fill the fuel tank. Refer to Fueling the Unit.

NOTE: There is no need to turn the unit on. The On/Off switch is in

the ON ( I ) position at all times (Fig. 4).

3. Slowly press and release the primer bulb 10 times (Fig. 5). If fuel

cannot be seen in the primer bulb, press and release the primer

bulb until fuel is visible.

4. Move the choke lever to Position 1 (Fig. 5).

5. Stand in the starting position (Fig. 6). Hold the handlebar and

squeeze the throttle control with one hand. Hold the starter rope

with the other hand. Use one foot to hold the wheels in place.

6. Tilt the unit back slightly to bring the tines off the ground (Fig. 6).

NOTE: SQUEEZE and HOLD the throttle control for ALL further steps.

7. Squeeze the throttle control (Fig. 4) and pull the starter rope with

a controlled and steady motion 5 times (Fig. 6).

8. Continue to squeeze the throttle control. Move the choke lever

to Position 2 (Fig. 5).

9. Continue to squeeze the throttle control. Pull the starter rope with

a controlled and steady motion 3 to 5 times to start the engine.

10. Continue to squeeze the throttle control. Allow the engine to

warm up for 30 to 60 seconds.

11. Continue to squeeze the throttle control. Move the choke lever

to Position 3 (Fig. 5) and continue warming the engine for an

additional 60 seconds. The unit may be used during this time.

NOTE: The engine is properly warmed up when it accelerates

without hesitation.

IF... the engine hesitates, return the choke lever to Position 2 (Fig. 5)

and continue the warm-up.

IF... the engine does not start, begin the starting procedure with step 3.

IF... the engine fails to start after a few attempts, move the choke

lever to Position 3 and squeeze the throttle control. Pull the

starter rope with a controlled and steady motion 3 to 8 times.

The engine should start. If it does not, repeat this instruction.

IF... the engine is already warm, begin the starting procedure with

step 8.

Fig. 4

Throttle Control

Stop/Off (O)

Start/On (I)

Fig. 5

Position 2

Position 1

Position 3

Fig. 6

Starter Rope Grip

Starting Position

Throttle

Control

On/Off Switch

Choke Lever

Primer Bulb

WARNING:

Operate this unit only in a well-ventilated

outdoor area. Carbon monoxide exhaust fumes can be

lethal in a confined area.

WARNING:

Avoid accidentally starting the unit. To avoid

serious injury, the operator and the unit must be in a stable

position when pulling the starter rope (Fig. 6).

WARNING:

The tines may rotate during the starting

process. Always stand in the starting position. Use one

foot to hold the wheels in place. Tilt the unit back slightly

to bring the tines off the ground.

STOPPING INSTRUCTIONS

1. Release the throttle control and allow the engine to idle.

2. Press and hold the On/Off switch in the OFF (O) position until

the engine comes to a complete stop (Fig. 4).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Comments to this Manuals

No comments

Remington RM4625 Operator's Manual Page 8

Comments to this Manuals