Remington RM4625 Operator's Manual download pdf (Page 6)

INSTALLING AND ADJUSTING THE WHEEL ASSEMBLY

Installing the Wheel Assembly

1. Set the unit on its side (Fig. 1).

2. Insert the wheel assembly into the wheel bracket (Fig. 1).

3. Insert the clevis pin through the wheel bracket and wheel

assembly and lock it in place with the cotter pin (Fig. 1).

NOTE: It may be necessary to adjust the position of the wheel

assembly before using the unit.

Adjusting the Wheel Assembly

1. Set the unit on its side (Fig. 1).

2. Remove the cotter pin and the clevis pin from the wheel bracket

and wheel assembly (Fig. 1).

3. Adjust the height by moving the wheel assembly along the wheel

bracket.

4. Insert the clevis pin through the wheel bracket and assembly

and lock it in place with the cotter pin (Fig. 1).

NOTE: Moving the wheel assembly down will raise the wheel height.

Moving the wheel assembly up will lower the wheel height.

ASSEMBLY

WARNING: To avoid injury from the tines, wear heavy

gloves and a long sleeve shirt when installing the wheel

assembly.

WARNING: To prevent serious personal injury, the wheel

assembly must be installed when operating the unit.

POSITIONING THE HANDLEBAR

1. Set the unit upright.

2. Loosen the knobs (Fig. 3).

3. Swing the handlebar up into the operating position (Fig. 2).

NOTE: Take care not to pinch the cables when positioning the

handlebar (Fig. 3).

4. Tighten the knobs securely.

NOTE: Do not over tighten the knobs.

5. Readjust the cables so they are smooth and tight against the

handlebar.

Fig. 2

Knobs

Fig. 3

Cables

Knobs

Fig. 1

Clevis Pin

Wheel

Assembly

Wheel

Bracket

Lower Raise

Cotter Pin

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Comments to this Manuals

No comments

Remington RM4625 Operator's Manual Page 6

Comments to this Manuals