Remington RM4625 Operator's Manual download pdf (Page 10)

MAINTENANCE

TINE REMOVAL AND REPLACEMENT

NOTE: All installation instructions are explained from the operating

position.

All 4 tines should be replaced at the same time because they will

wear evenly through normal use. Work on one side at a time.

1. Stop the engine and allow it to cool. Grasp the spark plug wire

firmly and pull the cap from the spark plug.

2. Lay the cultivator back on a flat level surface with the handles

touching the ground so that the cultivator is in a horizontal position.

NOTE: It may be necessary to wash any dirt off the tines and shaft

for easier tine removal.

3. Remove the cotter pins from each end of the tine shaft (Fig. 9).

Slide the tines off of the shaft (Fig. 8).

4. Clean and oil the shaft.

5. Slide on the new tines with the hubs facing in towards each

other (Fig. 8). Making sure that the rotation arrows are facing the

gearbox when installing the tines on left tine shaft and away

from the gearbox for the right tine shaft. (Fig. 9)

6. Secure the new tines to the shaft with cotter pins (Fig. 9).

7. Reconnect the spark plug wire.

WARNING: To prevent serious personal injury, always

wear heavy gloves when handling the tines.

Fig. 8

Left

Tine Shaft

Fig. 9

Right

Tine Shaft

Rotation Arrow

Hubs

Cotter Pin

Tines

Gearbox

MAINTENANCE SCHEDULE

Perform these required maintenance procedures at the frequency

stated in the table. These procedures should also be a part of any

seasonal tune-up.

NOTE: Some maintenance procedures may require special tools or

skills. If you are unsure about these procedures, take the unit to

an MTD authorized service dealer.

NOTE: Maintenance, replacement, or repair of the emission control

devices and system may be performed by an MTD authorized

service dealer.

NOTE: Please read the California/EPA statement that came with the

unit for a complete listing of terms and coverage for the

emissions control devices, such as the spark arrestor, muffler,

carburetor, etc.

WARNING:

To prevent serious injury, never perform

maintenance or repairs while the unit is running. Always

allow the unit to cool before servicing or repairing the unit.

Disconnect the spark plug wire to prevent the unit from

starting accidentally.

FREQUENCY MAINTENANCE REQUIRED

Every 10 hours Clean and re-oil the air filter. Refer to

Maintaining the Air Filter.

Every 25 hours Check the spark plug condition and gap. Refer

to Maintaining the Spark Plug.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comments to this Manuals

No comments

Remington RM4625 Operator's Manual Page 10

Comments to this Manuals

Related products and manuals for Mini tillers Remington RM4625