Remington IPL6500 Troubleshooting Guide download pdf (Page 12)

, PREPARE THE i-LIGHT FOR USE

• Unwrap the hand piece cord from the i-LIGHT base and rest the hand piece back on the base unit.

• EnsurethepowerswitchonthebaseunitisOFF.

• Connectthepowercordtothei-LIGHTbaseunitatthepowerinlet.

• Connectthepowercordtothewalloutlet.TurnthepowerswitchON.(fig.5)

, SELECTING THE ENERGY LEVEL

• The i-LIGHT is equipped with 5 energy levels. Level 1 is the lowest setting and level 5 is the highest

setting.

, TIP: For the most effective results, always use the highest energy level that does not cause discomfort

on the skin.

• Todeterminetheenergylevelbeingused,observethenumberoflightsilluminatedontheEnergy

Level Display (fig. 6).

• Youri-

LIGHT

will automatically be set to Energy Level 1 each time the device is powered ON. To

change the level, press the Energy Level Selection Button.

, TEST THE i-LIGHT ON YOUR SKIN

, Before your first full treatment, test the i-LIGHT on a small patch of skin and wait 24 hours to

ensure there are no adverse reactions.

• Start at energy level 1.

1 Place the i-

LIGHT

hand piece against your skin so the Flash Window is flush with the skin surface.

2 Ensure the Skin Contact Sensors are fully engaged and the Bulb Status Indicator Display is illuminated

green (Fig. 7).

Fig. 5

Fig. 6

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Remington IPL6500 Troubleshooting Guide Page 12