Remington i-Light Pro Face & Body Troubleshooting Guide Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 204
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
14
ENGLISH
C
CLEANING YOUR i-LIGHT DEVICE
F CAUTION: Before cleaning your i-Light, make sure that the power switch is OFF and the
power cord is disconnected from the base unit.
• Regularcleaninghelpstoensureoptimalresultsandalonglifeforthei-Lightdevice.Theexteriorsurface
of the base unit and hand piece may be wiped clean with a slightly damp cloth.
• TocleantheFlashWindow,useonlythelint-freeclothincludedwithyouri-Lightdevice.Takecarenotto
scratchorchiptheFlashWindow.Scratchesandchipscanreducetheeectivenessoftheunit.
• Forstubbornstains,useadampenedcottonswabtoapplyasmallamountofwatertotheFlashWindow
and clean with the lint-free cloth provided.
• Useasmallhand-heldvacuumtoremovedustanddebrisfromthehandpiecevents.
F WARNING: If the Flash Window is cracked or broken, the unit must not be used. Never scratch the lter
glass or the metallic surface inside the Treatment Head.
F CAUTION: The i-Light is a high voltage device. Never immerse in water. Never clean the unit or any of its
partsunderataporinadishwasher.Donotusepetroleum-basedorammablecleaningagentsbecauseof
the risk of re. Never use scouring pads, abrasive cleaning agents or aggressive liquids such as oil or acetone
to clean the unit.
E
TROUBLESHOOTING / STORAGE / MAINTENANCE
, i-Light Device Maintenance
F CAUTION: Before performing maintenance on your i-Light device, ensure that the power switch is OFF
and the power cord is disconnected from the base unit.
, Replacing the Bulb
1. Press the treatment head release buttons and gently pull to remove the treatment head.
2. Gently pull out the old bulb cartridge.
3. Replace with a new bulb cartridge.
F CAUTION:Whenreplacingthebulbcartridge,donottouchtheashbulbsdirectlyasthisleavesoilsand
residue.Doingsocouldreducetheeectivenessofthebulbsorcausethemtocrackduringtreatment.
4. Replacethetreatmenthead,makingsureitsnapsintoplace.
, Storage
• Switchotheunit,unplugitandletitcooldownfor10minutesbeforestorage.
• Storetheunitinadryplaceatatemperaturebetween15ºCand35ºC.
, Troubleshooting
Always read these instructions fully before using i-Light. Refer to this troubleshooting guide if you
experience any problems with i-Light, as this section addresses the most common problems you could
encounter with i-Light. If you have followed the instructions in this section and continue to experience
problems,pleasecontacttheRemington®ServiceCentreforfurtherassistance.
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 203 204

Comments to this Manuals

No comments