Remington MPS6017A Owner's Manual download pdf (Page 9)

MOWER INFORMATION

MOWER ASSEMBLY Adjusting Wheel Height

Attaching Handle AssemNy to Mower

1. Align endsof lower handle assemblywith

handle shafts on rear of mower (see Figure

1), Insert connector bolts, fl'om the inside

of the handle assembly, through both the

lower handle assembly and the handle

shafts (see Figure 2),

3, Place star-washer onto connector bolt and

thread on the handle knobs (see Figure 3),

Hand-tighten handle knobs securely,

4, Rotate top of handle assembly upward to

align with bottom of handle,

5, Tighten handle knobs (see Figure 4),

Adjusting Handle Height

The handle has three height adjustments (three

holes in the lower handle assembly). Adjust

the handle assembly to a comfortable height

for you.

1. Loosen and remove the handle knobs, con-

nector bolts, and star-washer (see Figure

4).

2. Adjust handle up or down to desired height

(see Figure 5).

3. Align holes on lower handle assembly with

hole in upper handle assembly.

4. Insert connector bolts, fi_om the inside of

the handle assembly, through both the

lower and upper handle assembly.

5. Place star-washer onto connector bolt and

thread handle knobs on loosely (see Figure

4).

6. Verify upper and lower handle assembly

are aligned and hand-tighten handle knobs

securely. Note: Be careful not to over-

tighten handle knobs and possibly strip

the threads.

Figure 1 - Align Lower Handle Assembly

Figure 2 - Insert Connector Bolts

Figure 3 - Thread on Handle Knobs

Figure 4 - Tighten Handle Knobs

Figure 5 - Adjusting Handle

There are 8 preset cutting height settings. The

cutting depth of the mower is adjustable from l

72" to 3 72" in approximately 1/4" increments.

Use the wheel height adjustment handle to

adjust all 4 wheels.

1. Remove key from mower.

2. Make sure all four wheels are level.

3. Slide the wheel height adjustment handle

out of the slot (see Figure 6).

Note: To easily adjust the cutting height,

hold the mower handle with one hand to

keep the mower steady and adjust the lever

with the other hand.

4. Move the handle forward or backward to

adjust cutting height (see Figure 7).

5. Slide the handle into the slot at the desired

height (see Figure 8).

Note: Setting 1 cuts the grass to 1 72" in

height (short cut). Setting 8 cuts the grass

to 3 72" in height (tall cut).

Figure 6 - Wheel Adjustment Handle

Figure 7- Move Handle

Check the handle height for comfort and adjust

as needed.

i!ilil;_,!!;.i.!!_!!4!

Figure 8 - Slid Handle into Slot

9 www.remingtonpowertools.com

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 62 63

Comments to this Manuals

No comments