Remington HC-8017B User Manual download pdf (Page 5)

4. If you have the HC-920, HC-921,HC-930,

or HC-8017 remove the trimming guide

and replace with either the left or right

ear guide.The shorter guide teeth are

designed to be toward the ear. Move the

clipper from the front of the head to the

back.This creates a tapered

effect around

the ears and back of the neck.

To trim around the ears and short hairs

at the nape of the neck with the HC-810

and HC-815, you must remove the trim-

ming guide.

Angle the clip-

per and lightly

stroke around

each ear to the

back of the

neck. Be careful

not to touch the

ears or to press

too hard.

5. The final trim

can be made with the hair clipper or the

included scissors.Make sure to check

over the entire head for any uneven

areas. For styled hair or giving quick

trims, you may prefer using your hair

clipper without the trimming guide.

9

Usage Tips

Giving a Comfortable,

Even Cut

Allow the clipper to cut through the hair

without moving it too quickly. Moving the

clipper too quickly may create a pulling

sensation.

Use short strokes when cutting, and initially

use the longest trimming guide.You can

always use a closer trimming guide later if

you want a closer cut.

How to Give a Haircut

1. Start at the back of the head. Holding the

clipper as shown, lightly stroke upward

making sure you

are taking off

the desired

amount of hair.

Work your way

up to the crown

of the head in

layers.When

completed,

comb the area

to remove any

loose hair and to determine whether you

need any further cutting.

2. Repeat the same procedure for each side

of the head. Make sure the length of the

hair is trimmed to the same length on

both sides of the head.

3. To cut the hair

at the top of the

head, hold the

hair between

your fingers and

cut a small

amount at a

time. Cut from

the front to the

back.

6. The adjustable taper control lever allows

you to gradually change the closeness of

your cut,

either with

or without a

trimming

guide.When

the lever is

fully forward

the blades

will give you the closest cut.Moving the

lever gradually backward increases the

cut length.

Very short styles

1. Using the 1/2” (12mm) trimming guide,

hold the comb

flat against the

head and move

the hair clipper

from the back of

the neck to the

crown of the

head.

2. Cut in a similar

manner from

the side to the

top of the head.Then cut from the front

to the crown of the head.

3. If a “Flat Top” style is desired,then

remove the trimming guide and use the

barber’s comb.Trim a little at a time until

a flat look is achieved.

Trimming Beards &

Mustaches

1. Comb your

beard in the

direction it

grows.

2. Determine the

length you want

the beard to

remain, and fit

the appropriate

trimming guide.

Remember the 1/8” (3mm) guide will

give you the shortest beard while the

1/2” (12mm) or 1” (25mm) will give you

the longest. If you want a longer beard

you can use the barber’s comb as a trim-

ming guide.

3. Start trimming under your chin and work

toward your ear and beard line. Cut in

different directions for a uniform trim.

4. Lightly stroke the edge of your mustache

in a downward movement.

8

G03-038 Haircut Kit I.B. 9/1/05 9:34 AM Page 8

1 2 3 4 5 6 7 8 9 10 ... 18 19

Comments to this Manuals

No comments