Remington H0747 Instruction for Use download pdf (Page 5)

ENGLISH

GBDNLFEIDKSFINPSKCZPL

HUN

RUTRROGRSLAE

HR/

SRB

Keep this product out of reach of children. The use of this appliance by persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge

can give cause to hazards. Persons responsible for their safety should give explicit

instructions or supervise the use of the appliance.

Avoid allowing any part of the rollers to contact the face, neck or scalp.

This appliance is not intended for commercial or salon use.

If the supply cord of this unit becomes damaged, discontinue use immediately and

return the appliance to your nearest authorised Remington

service dealer for repair or

replacement in order to avoid a hazard.

Special tools are required for any examination, adjustment or repair. Unqualiﬁed repair

work could lead to hazardous conditions for the user.

We do not accept responsibility for damage to the product, persons or other item(s),

caused by misuse, abuse or non-compliance with these instructions.

WIRING INSTRUCTIONS UK Plugs Only

This product is ﬁtted with a BS1363 plug fused at 5A. If the plug is unsuitable, it should be

disconnected and an appropriate plug ﬁtted as detailed below. If it is necessary to replace

the plug fuse, use only fuses that are approved to BS1362, rated at 5A. If in doubt consult a

qualiﬁed electrician.

The wires in the mains lead are coloured in accordance with following code:

GREEN AND YELLOW - EARTH

BLUE - NEUTRAL

BROWN - LIVE

As these colours may not correspond with the coloured markings sometimes used to

identify the terminals in a plug connect as follows:

The wire coloured Green and Yellow must be connected to the terminal marked E or by

the earth symbol or coloured Green, or Green and Yellow. The wire coloured Blue must

be connected to the terminal marked N or coloured Black. The wire coloured Brown must

be connected to the terminal marked L or coloured Red.

NEW WIRING

COLOUR CODE

BLUE

TO NEUTRAL

BROWN

TO LIVE

100534 REM IFU KF20i 22L.indd GB_3100534 REM IFU KF20i 22L.indd GB_3 29.07.10 17:2629.07.10 17:26

Do not leave the rollers unattended when switched on.

Allow heated rollers to cool down before storage.

Do not immerse in water or other liquids.

Do not wrap the cord around the unit. Check cord regularly for any sign of damage.

Damaged cords can be dangerous.

Do not place rollers on soft material e.g. carpet, bedding, towels, rugs etc.

Always ensure the voltage to be used corresponds to the voltage stated on the unit.

1 2 3 4 5 6 7 8 9 10 ... 72 73

Comments to this Manuals

No comments

Remington H0747 Instruction for Use Page 5

Comments to this Manuals

Related products and manuals for Hair rollers Remington H0747