Remington REM10PT User Manual download pdf (Page 12)

110373-01B

For more information, visit www.desatech.com

CLEANING AND MAINTENANCE

ODS/Pilot and Burner

Cleaning Burner Pilot Air Inlet

Cabinet

CABINET

Air Passageways

• Use a vacuum cleaner or pressurized air to clean.

Exterior

• Use a soft cloth dampened with a mild soap and water mixture.

Wipe the cabinet to remove dust.

Figure 22 - Pilot Inlet Air Hole

Pilot Assembly

Pilot Air Inlet

Hole

CLEANING AND

MAINTENANCE

ODS/PILOT AND BURNER

• Use a vacuum cleaner, pressurized air, or small, soft bristled

brush to clean.

CLEANING BURNER PILOT AIR INLET

The primary air inlet holes allow the proper amount of air to mix with

the gas. This provides a clean burning flame. Keep these holes clear

of dust, dirt, and lint. Clean these air inlet holes prior to each heating

season. Blocked air holes will create soot. We recommend that you

clean the unit every three months during operation and have heater

inspected yearly by a qualified service person.

We also recommend that you keep the burner tube and pilot

assembly clean and free of dust and dirt. To clean these parts we

recommend using compressed air no greater than 30 PSI. Your local

computer store, hardware store, or home center may carry com-

pressed air in a can. You can use a vacuum cleaner in the blow

position. If using compressed air in a can, please follow the direc-

tions on the can. If you don't follow directions on the can, you could

damage the pilot assembly.

1. Shut off the unit, including the pilot. Allow the unit to cool for

at least thirty minutes.

2. Inspect burner, pilot for dust and dirt.

3. Blow air through the ports/slots and holes in the burner.

4. Never insert objects into the pilot tube.

Clean the pilot assembly also. A yellow tip on the pilot flame

indicates dust and dirt in the pilot assembly. There is a small pilot

air inlet about two inches from where the pilot flame comes out of

the pilot assembly (see Figure 22). With the unit off, lightly blow air

through the air inlet. You may blow through a drinking straw if

compressed air is not available.

WARNING: Turn off heater and let cool before

cleaning.

CAUTION: You must keep control areas, burner,

and circulating air passageways of heater clean.

Inspect these areas of heater before each use. Have

heater inspected yearly by a qualified service person.

CAUTION: You must check and keep burner/

venturi tubes clean of insect and insect nest. A

clogged tube can lead to a fire.

(Propane/LP

Pilot Shown)

Pilot Assembly

Pilot Air Inlet

Figure 23 - Injector Holder On Burner Tube

Burner

Tube

Injector Holder

Ports/Slots

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Comments to this Manuals

No comments

Remington REM10PT User Manual Page 12

Comments to this Manuals