Remington RM2520 Operator's Manual download pdf (Page 6)

ASSEMBLY

INSTALLING THE CUTTING HEAD SHIELD

Use the following instructions if the cutting head shield is not

installed. Use only the instructions that apply to the type of shaft

and shield equipped with this unit.

1. Remove the wing nut and washer from the cutting head shield.

2. Insert the short tab (the one without a hole) on the mount

bracket into the slot on the cutting head shield (Fig. 1).

3. Rotate the cutting head shield counterclockwise to align the hole

on the cutting head shield with the hole on the mount bracket

(Fig. 1).

4. Insert the square bolt into the hole underneath the cutting head

shield (Fig. 2). Push the square bolt through the cutting head

shield and mount bracket.

5. Put the washer onto the square bolt (Fig. 2).

6. Screw the wing nut onto the square bolt until the cutting head

shield is firmly in place (Fig. 2).

Fig. 1

Mount Bracket

Cutting Head

Shield

WARNING:

To prevent serious personal injury, never

operate the unit without the cutting head shield in place.

Fig. 2

Washer

Square Bolt

Slot

Wing Nut

Cutting Head

Shield

Mount Bracket

Fig. 3

Bolt

Shaft Grip

Minimum 6 in.

(15.24 cm)

Washer

Handle

Tighten

Wing Nut

INSTALLING AND ADJUSTING THE HANDLE

Installing the Handle

1. Push the handle down onto the shaft housing (Fig. 3). The

square bolt hole in the handle should be to the right.

2. Insert the bolt into the square bolt hole and push it through (Fig.

3). Place the washer onto the bolt. Screw the wing nut onto the

bolt, but do not tighten the wing nut completely .

3. While holding the unit in the operating position (Fig. 10), move

the handle to the location that provides the best grip. Place it a

minimum of 6 inches (15.24 cm) from the end of the shaft grip

(Fig. 3).

4. Tighten the wing nut until the handle is secure.

Adjusting the Handle

If the handle requires adjustment:

1. Loosen the wing nut (Fig. 3).

2. While holding the unit in the operating position (Fig. 10), move

the handle to the location that provides the best grip. Place it a

minimum of 6 inches (15.24 cm) from the end of the shaft grip

(Fig. 3).

3. Tighten the wing nut until the handle is secure.

1 2 3 4 5 6 7 8 9 10 11 ... 55 56

Comments to this Manuals

No comments

Remington RM2520 Operator's Manual Page 6

Comments to this Manuals

Related products and manuals for Grass trimmers Remington RM2520