Remington RM2520 Operator's Manual download pdf (Page 12)

Part 2 - Winding New Trimming Line onto the Inner Reel

• If using single line, refer to Winding Single Line.

• If using split line, refer to Winding Split Line.

• If using a prewound inner reel, proceed to Part 3 - Installing the

Inner Reel.

Winding Single Line

1. Cut two 8-foot (2.4 m) lengths of new single trimming line.

2. Insert the end of one line into the top hole in the inner reel (Fig.

16A). Wind the line tightly in the direction shown on the bottom

of the inner reel until about 6 inches (150 mm) of line remains.

Keep the line above the split wall. Insert the 6-inch section into

the nearest .095 holding slot (Fig. 16B).

3. Insert the end of the other line into the bottom hole in the inner reel

(Fig. 17A). Wind the line tightly in the direction shown on the bottom

of the inner reel until about 3 to 9 inches (75 to 225 mm) of line

remains. Keep the line below the split wall. Insert the 3 to 9-inch

section into the opposite .095 holding slot (Fig. 17B).

NOTE: Failure to wind the line in the direction indicated will cause

the cutting head to operate incorrectly.

Proceed to Part 3 - Installing the Inner Reel.

Winding Split Line

1. Cut one 6-foot (1.8 m) length of new split line trimming line. Split

each end about 6 inches (150 mm).

2. Using one split end, insert one line into the top hole and the

other line into the bottom hole in the inner reel (Fig. 18A).

3. Wind the line tightly in the direction shown on the bottom of the

inner reel. The split wall will automatically divide the line. Wind

the line until it is completely divided and about 6 inches (150

mm) of line remains.

NOTE: Failure to wind the line in the direction indicated will cause

the cutting head to operate incorrectly.

4. Insert the two 6-inch sections into the two .095 holding slots

(Fig. 18B).

Proceed to Part 3 - Installing the Inner Reel.

Part 3 - Installing the Inner Reel

1. Pass the two line ends through the eyelets in the outer spool.

Place the spring inside the inner reel. Insert the inner reel into

the outer spool. Push the inner reel and outer spool together

(Fig. 19).

NOTE: The spring must be assembled on the inner reel before

reassembling the cutting head.

2. While holding the inner reel and outer spool together, firmly pull

the two line ends to release them from the holding slots.

3. While holding the inner reel and outer spool together, screw the

bump knob on clockwise. Tighten the bump knob securely.

Fig. 18

Fig. 19

Top Hole

Outer Spool

Fig. 16

Top Hole

Fig. 17

Holding Slot

Bottom Hole

Holding Slot

Bottom Hole Holding Slots

Split

Wall

Split

Wall

Split

Wall

Bump Knob

Inner ReelSpring

Eyelets

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Comments to this Manuals

No comments

Remington RM2520 Operator's Manual Page 12

Comments to this Manuals

Related products and manuals for Grass trimmers Remington RM2520