Remington RM2520 Operator's Manual download pdf (Page 11)

DECORATIVE TRIMMING

When trimming around trees, posts, fences, etc., rotate the whole

unit so that the cutting head is at a 30° angle to the ground (Fig. 12).

EDGING

The trimmer attachment can be used for edging (Fig. 13).

Alternatively, bladed lawn edger attachments can also be purchased

for use with this unit.

Rotating the Trimmer Attachment

When edging around sidewalks, flowerbeds, etc., rotate the trimmer

attachment 90° inside the coupler. DO NOT rotate the entire unit 90°.

1. Turn the knob counterclockwise to loosen the coupler (Fig. 4).

Refer to Operating the Coupler in the Assembly section.

2. Press and hold the release button (Fig. 6).

3. Rotate the attachment until the release button snaps firmly into

the 90° edging hole (Fig. 14).

4. Turn the knob clockwise to tighten the coupler (Fig. 4).

Maintaining the Trimming Line

Hard surfaces, such as sidewalks, can cause the trimming line to

wear down quickly or break.

• Frequently check and adjust the trimming line length. Refer to

Adjusting the Trimming Line Length. Always keep the trimming

line fully extended.

• DO NOT force the unit. Make shallow cuts in as many passes as are

necessary to achieve the desired depth. Cut at a slow, even pace.

Fig. 13

CAUTION:

Only snap the release button into the 90°

edging hole when edging with the trimmer attachment.

Using the 90° edging hole with other attachments could

lead to personal injury or damage to the unit.

WARNING:

To avoid serious personal injury and

damage to the unit, shut the unit off before rotating the

attachment.

Fig. 14

Release Button

90˚ Edging Hole

Fig. 12

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

No comments

Remington RM2520 Operator's Manual Page 11