Remington Precision Beard & Mustache Trimmer User Manual

Browse online or download User Manual for Grass trimmers Remington Precision Beard & Mustache Trimmer. Professional

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Professional
® Registered Trade Mark of Spectrum Brands, Inc., or one of its
subsidiaries.
Rev. 07/09 Part No. T22-28642 ©2009 SBI.
Do not use liquid cleaners and harsh or corrosive cleaners on
the groomer, blades or attachments.
The groomer is suitable for cleaning under the tap with warm
water.
IMPORTANT SAFETY INSTRUCTIONS
When using the Washable Personal Groomer, basic precautions
should always be observed, including the following.
READ ALL INSTRUCTIONS BEFORE USING.
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION
AND FIRE OR INJURY TO PERSONS
Do not use this groomer while it is connected to the Charging Adaptor.
Do not place or store the Charging Adaptor where it can fall or be
knocked into a sink or bath. Do not place in or drop into water or any
other liquid.
Unplug the Charging Adaptor from the electrical outlet immediately after
use.
Use this groomer only for its intended use as described in this manual.
Do not use attachments not recommended by Remington.
• Never drop or insert any object into any opening of this groomer.
Do not use this groomer with a damaged or broken cutting attachments
or with damaged or broken cutting blades.
Always store the Charging Adaptor in a moisture-free location.
• This groomer is manufactured for home use only.
Keep this product out of reach of children. The use of this appliance
by persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge can give cause to hazards. Persons
responsible for their safety should give explicit instructions or supervise
the use of the appliance.
Ensure that the groomer is detached from the Charging Adaptor when
cleaning.
If the Charging Adaptor becomes damaged or faulty it must be replaced.
TO SHAVE USING THE MINI-FOIL SHAVER HEAD ATTACHMENT
Shaver head attachment should be on the groomer.
Hold the groomer so the shaver gently touches your face.
Use short well-controlled movements to shave around your
beard or moustache.
NOTE: The Mini-Foil Shaver Head Attachment is designed to
shave the detailed areas of your beard, moustache and sideburns.
It is not designed to shave your entire face.
CLEANING AND MAINTAINING YOUR GROOMER
We recommend you clean your Washable Personal Groomer after
each use. The easiest and the most hygienic way to clean the
groomer is by rinsing the product head after use with warm water.
Always keep the groomer in the 'off' position when not in use.
AFTER EACH USE
After each use, brush or rinse the accumulated hair from the Groomer
Attachments. Ensure that the blades are dry before applying oil.
To clean the body of the groomer, wipe with a damp cloth and
dry immediately.
EVERY SIX MONTHS
The Blade Sets should be separated and cleaned. To separate the
blades, remove the two screws holding the blade in place on the
trimmer attachment. The blade will separate from the housing
and both top and bottom blades can be cleaned as necessary. Do
not attempt to remove the small oscillating blade. Replace the
top blade, being sure that the teeth of the two blades are parallel
before finally tightening the screws and then apply a few drops of
Lubricating oil to the blades.
CLEANING CAUTIONS
Cleaning should be done with a soft brush, such as the cleaning
brush supplied with the product.
Only use the light grade oil supplied or sewing machine oil on
the blades, as it will not evaporate.
Remington® strongly recommends that an approved Safety
Switch (Residual current device) be installed to protect all
bathroom power outlets. Ask an electrical contractor for advice.
SAVE THESE INSTRUCTIONS
This Groomer conforms to Radio Frequency requirements.
Warranty information can be found in the enclosed warranty card.
Any product purchased and used commercially carries a limited
90 day warranty.
Remington Products
Australia Pty Ltd
Chifley Business Park
1 Chifley Drive
Mentone, Victoria, 3194
Australia
Remington Products
New Zealand Ltd
600 Great South Road
Building C, Ground Floor
Greenlane, 1051, Auckland
New Zealand
TRIMMING NOSE, EAR & EYEBROW HAIR
To remove hair from the nose:
• Nose, Ear and Eyebrow Attachment should be on the groomer.
• Turn groomer on.
Insert the cutting unit gently into the opening of the nostril.
Rotate the groomer in a circular motion around the opening of
the nostril.
For the best cutting efficiency, gently move the groomer in and
out of the nostril as you rotate it.
Avoid inserting the groomer more than 5-6mm into your nostril
to ensure safe trimming.
To remove hair from the ear:
To remove hair from the eyebrows:
To remove hair from the ear:
Nose, Ear and Eyebrow Attachment should be on the groomer.
Turn the groomer on.
Insert the groomer’s cutting unit gently into the outer ear canal
opening.
Gently rotate the groomer in a circular motion.
To trim hairs protruding from the surface of the ear and
surrounding the outer ear canal, guide the groomer around the
edge of the ear.
Avoid inserting the groomer more than 5 – 6mm into your ear
canal to ensure safe trimming.
To remove hair from eyebrows:
Nose, ear, eyebrow attachment should be on the groomer.
Turn the groomer on.
Gently guide the cutting unit to stray, unwanted hairs along the
eyebrow line or protruding from the eyebrow itself.
Move the groomer slowly and carefully, so as not to
accidentally cut any hairs that you do not intend to trim.
It is not recommended that you use the groomer to define or trim
the entire eyebrow.
www.remington-products.com.au
Page view 0
1 2

Summary of Contents

Page 1 - Professional

Professional® Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries.Rev. 07/09 Part No. T22-28642 ©2009 SBI.• Do not use liqu

Page 2 - Diagram 5

GETTING STARTEDCHARGING YOUR GROOMERBefore using your Groomer for the first time, charge for 14 to 16 hours.• Check to ensure that the Groomer On/Off

Comments to this Manuals

No comments