Remington ST3010A User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
 
118336
11. Position each line section in the slots
on either side of the retaining ring
(see Figure 4-20).
12. Hold the retaining ring in place
and make sure the line remains in
the retaining ring slots. Rotate the
spool while holding the retain-
ing ring in place. e line will roll
onto the spool (see Figure 4-21).
IMPORTANT: Make sure to rotate the
spool so the line winds onto spool in
the direction indicated on the spool
top. Wind line until four inches of
line remains outside the spool.
13. Replace spool onto spool spring and
press spool down. Lay exposed trim-
mer line into slots on spool housing
(see Figure 4-22).
14. Align tabs on spool cover with slots
in spool housing. Replace spool cover
onto spool housing and snap into
place (see Figure 4-23).
Figure 4-20: Positioning line in retaining ring slots
Figure 4-19: Placing retaining ring onto spool
Lines Through
Slots in
Retaining Ring
Figure 4-21: Winding line onto spool
Figure 4-22: Replacing spool into spool housing
Figure 4-23: Replacing spool cover onto spool housing
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Comments to this Manuals

No comments