Remington BS1812A User Manual download pdf (Page 11)

11

www.desatech.com

TRIMMER/EDGER OPERATION

ENGLISH

Figure 17 - Positioning hand on front

handle.

Figure 18 - Depress lockout button and

squeeze trigger

Figure 19 - Release lockout button

TRIMMING

To reduce excessive line wear and improve

trimming performance, follow the steps below

to trim grass and weeds.

1. Remove any string, wire, or other mate-

rials that could become entangled in the

trimmer/edger from the trimming area.

2. Hold trimmer/edger using both front and

rear handles (See Figure 20).

3. Slowly sweep the trimmer/edger from

side to side or front to back.

4. Do not force the trimmer/edger. Allow

only the tip of the trimmer/edger line to

cut the grass or weeds.

5. If grass or weeds are tall, cut them in

several increments, starting from the top

and working to the bottom.

Figure 20 - Holding trimmer/edger

ADVANCING TRIMMER LINE

To advance new trimmer/edger line, tap the

line advance button on the ground while the

trimmer/edger is running (See Figure 21. The

blade attached to the cutting guard will cut the

line to the proper length.

Follow the precautions below to ensure top

line performance.

• Do not hold the line advance button on the

ground. This will allow trimmer/edger line

to constantly feed off the spool.

• Tap the line advance button only once to

advance line. If more line is needed, wait

a few seconds and tap again.

• Be sure to advance the line as it wears

down. If you wait too long to advance new

line, the existing line will wear down too

short and can retract into the spool. If this

happens, remove the spool and reroute the

line out of the spool. Reinstall the spool to

the spool housing.

Blade is sharp. To prevent

serious injury, do not touch

blade.

Figure 21 - Advancing trimmer/edger line

WARNING:

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Comments to this Manuals

No comments