Remington Axcess AT3017BCA User Manual download pdf (Page 9)

9

120050

OWNER’S MANUAL

For more information, visit www.desatech.com

SERVICING POLE

TRIMMER

The Pole Trimmer is a double-insulated tool

and contains some parts that can only be

replaced with original parts by an Autho

-

rized Service Center. Visit our Technical

Service web site at www.desatech.com

or contact our Technical Service Department

at 1-800-858-8501 (English Only) for the

nearest Authorized Service Center.

The parts listed on pages 12 and 13 are

considered to be user replaceable. See Re-

placement Parts and Accessories, page 10,

for information on ordering these parts.

1. Unplug pole trimmer from power supply.

2. Place pole trimmer upside down on

workbench and remove the four (4)

bottom cover screws. Lift bottom cover

off (see Figure 18).

WARNING: To prevent serious

personal injury, wear gloves when

removing and installing the cut

-

ter blades. Do not place ﬁngers

or hands between blades where

they could get cut.

BLADE REPLACEMENT

3. Remove M5 locknut and washer from

cam (see Figure 19).

4. Align cam and cutter blade assemby.

Remove cam. (see Figure 19).

Cover Screw

Bottom Cover

Figure 18 - Removing Bottom Cover from

Trimmer Head

M5 Locknut

Washer

Cam

Figure 19 - Removing Cam

Cutter Blade Assembly

Note: If binding occurs after reassembly,

repeat all of the previous steps making sure

that cam aligns properly with cutter blade

assembly.

WARNING: All components

must be installed and securely

fastened before plugging pole trim

-

mer into power supply. Failure to

do so may cause product damage

or serious personal injury.

5. Remove screw that holds down cutter

blade assembly (see Figure 20). IM-

PORTANT: Be sure not to loose the

8-32 locknut that secures this screw.

6. Remove and dispose of cutter blade

assembly.

7. Attach new cutter blade assembly to

power head with screw and locknut

removed in step 5.

8. Align cutter blade assembly so that

the cam will ﬁt properly into the oval-

shaped lobes of the cutter blade assem

-

bly (see Figure 19). IMPORTANT: The

large diameter ﬂange of the cam must

face upward away from the power head.

The small diameter ﬂange of the cam

must line up with and sit directly on top

of the cam ﬂange.

9. Replace washer and locknut removed

in step 3. Tighten securely.

10. Replace the bottom cover and se-

cure with the 4 bottom cover screws

removed in step 2 (see Figure 18).

Tighten screws securely.

Figure 20 - Removing Cutter Blade

Assembly

Screw

Cutter Blade

Assembly

Cam Flange

8-32 Locknut

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Comments to this Manuals

No comments