Remington Axcess AT3017BCA User Manual download pdf (Page 4)

4

120050

ELECTRIC POLE TRIMMER

®

For more information, visit www.desatech.com

OPERATING POLE

TRIMMER

WARNING: Read and under-

stand this owner’s manual before

operating Pole Trimmer. Make cer-

tain you read and understand all

Safety Warnings on pages 2 and

3 of this manual. Improper use

of this Pole Trimmer can result in

severe injury or death from ﬁre,

electric shock, or body contact

with moving parts.

2. Grasp the power head motor housing

and rotate the power head to either the

0, 45, or 90 degree position.

CONNECTING EXTENSION

CORD

The Pole Trimmer has a built-in extension

cord retainer to prevent the accidental discon-

nection of the unit from the extension cord

during use. It is molded into the lower hand

guard area of the trigger housing.

1. Make sure the trigger lever is in the

OFF position (see Starting the Pole

Trimmer, page 5).

2. Plug the power cord into the extension

cord.

PIVOTING THE POWER HEAD

The Pole Trimmer is equipped with a power

head that pivots. The power head is able to

pivot a full 180 degrees. The power head

has a spring-loaded T-handle that allows it

to be locked into several different positions

within its 180-degree rotation.

Before connecting the Pole Trimmer to the

electrical supply, make sure the power head

is locked into position. Do this by trying to

rotate the power head in either direction. The

power head should be locked in position and

should not rotate.

To pivot the power head, follow the instruc-

tions below.

1. Pull out on the T-handle located on the

side of the pivot bracket. The T-handle

is spring-loaded, so you will feel some

resistance when pulling it out.

3. Release the T-handle. It should snap

back into its seated position. If it does

not, rotate the power head back and

forth slightly until the T-handle snaps

back into its seated position. The power

head is now locked into position and

ready for use.

Figure 5 - Plugging Pole Trimmer Power

Cord to Extension Cord

Figure 3 - Rotating Power Head

Figure 4 - Locking Power Head Into

Position

Figure 2 - Pulling Out T-Handle to Rotate

Power Head

Cord Length AWG Cord Size

25 feet 18 AWG

50 feet 16 AWG

100 feet 16 AWG

150 feet 14 AWG

EXTENSION CORDS

Use proper extension cord with this Pole

Trimmer. Use only extension cords marked

for outdoor use. The cord must be marked

with sufﬁx W or W-A following the cord type

designation.

Example: SJTW-A or SJTW.

Use proper sized cord with this Pole Trimmer.

Cord must be heavy enough to carry current

needed. An undersized cord will cause volt-

age drop at Pole Trimmer. Pole Trimmer will

lose power and overheat. Follow cord size

requirements listed below.

Keep cord away from cutting area. Make

sure cord does not catch on branches dur-

ing cutting. Inspect cord often. Replace

damaged cords.

1 2 3 4 5 6 7 8 9 ... 43 44

Comments to this Manuals

No comments