Remington 117535-01 Owner's Manual download pdf (Page 7)

7

110939

OWNER’S MANUAL

For more information, visit www.desatech.com

TRIMMING A HEDGE

Use the Pole Trimmer properly. Always

wear eye protection, rubber gloves, and

substantial foot wear while using the Pole

Trimmer. Always maintain proper footing

and balance and never overreach when us-

ing Pole Trimmer. Before starting the Pole

Trimmer, hold the unit with both hands on

the grip areas. Make sure that the cutter blade

is not touching anything.

Always keep the extension cord behind the

Pole Trimmer when in use. Do not drape

the cord over the hedge where it may be

cut by the blades.

Use smooth steady sweeping motions to trim

new growth. Do not try to cut too much at

one time. This can cause the Pole Trimmer

to slow down or get jammed, reducing the

cutting efﬁciency.

CLEANING AND

MAINTENANCE

WARNING: Disconnect Pole

Trimmer from power supply before

cleaning or servicing. Severe in-

jury or death could occur from ﬁre,

electrical shock, or body contact

with moving cutter blades.

WARNING: When cleaning

Pole Trimmer:

• Do not submerse Pole Trimmer

in any liquids

• Do not use products that con-

tain Ammonia, Chlorine, or

abrasives

• Do not use chlorinated cleaning

solvents, Carbon Tetrachloride,

Kerosene, or Gasoline.

Use a soft cloth dampened with a mild soap

and water mixture to wipe Pole Trimmer

pole, housing, and cutter blades clean. Do

not spray or pour water directly onto Pole

Trimmer.

Once the Pole Trimmer is cleaned, apply

a light coat of oil to the cutter blades to

prevent rust and provide lubrication (motor

oil is preferred).

Figure 16 - Trimming Hedge

Do not force the Pole Trimmer through dense

growth. A slight back and forth sawing action

may ease the cutting of larger, more dense

growth. If the Pole Trimmer begins to slow

down, reduce the rate of speed at which you

are trying to cut.

If the Pole Trimmer becomes jammed, im-

mediately turn Pole Trimmer off. Discon

-

nect Pole Trimmer from the power supply

and remove the jammed debris from the

cutter blades.

Do not try to cut branches larger than

3/4 inch in diameter.

For best results, trim the sides of hedges with

an upward sweeping motion. Trim the hedges

so that the top is slightly narrower than the

bottom. To trim extremely level hedges, use a

string stretched along the length of the hedge

as a guide (see Figure 16).

OPERATING POLE

TRIMMER

Continued

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Comments to this Manuals

No comments