Remington EP6020 Instruction for Use Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 11
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
080757_REM_IFU_EP3000_EP4000_22L.indd Sec2:3080757_REM_IFU_EP3000_EP4000_22L.indd Sec2:3 05.11.2008 14:18:44 Uhr05.11.2008 14:18:44 Uhr
3
ENGLISH
Your epilator cannot be overcharged. However, if the product is not going to be used for an
extended period time (2-3 months), unplug it from the mains and store. Fully recharge your
epilator when you would like to use it again.
To preserve the life of your batteries, let them run out every six months then recharge for
CORDED MODELS
Ensure the epilator is OFF and attach the mains adaptor to the product and then to the mains.
Ensure the epilator is OFF and attach the mains adaptor to the mains.
CHARGING CAUTIONS
Always charge epilator in a cool, dry place.
Do not charge/use the epilator in close proximity to water.
The epilator can be attached to a mains voltage of 0V – 240V (UK, Europe, Australia
standard). Please check the voltage of your destination country before travel.
NOTE: EP6030 can also be used corded. Please follow the instructions below.
(EP6020)
16 hours.
HOW TO USE
Before epilating, make sure that your skin is clean, dry and free from creams or oils.
Remove protective cap and turn the epilator on to the desired speed. Low is recommended
for fine hair and high is recommended for course hair or stronger hair growth.
INSTRUCTIONS FOR CHARGING
Always ensure that your hands, epilator and mains adaptor are dry before charging this product.
RECHARGEABLE MODELS
Before using your Remington® epilator for the first time, charge for 24 hours. For
subsequent uses, charge for 16 hours before use . One full charge allows for up to 40mins usage time.
Ensure the epilator is OFF and attach the mains adaptor to the epilator.
Connect the mains adaptor to the mains. The charging indicator light will illuminate.
Charge for the time indicated above.
Use product until the battery is low. This is indicated by the epilator running distinctly slower.
Using your free hand, hold the skin taut to make the hairs stand upright.
(EP6030)
Position the epilator flat so that the stainless steel discs are at 90º angle and flat against the skin.
The Remington® epilation head is curved to ensure maximum contact with the area of hair removal.
(Diagram A)
10
Page view 5
1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments