Remington RM112ST Owner's Manual download pdf (Page 6)

 



10.

Provide Ground Fault Circuit Inter-

rupter (GFCI) protection on the

circuit or outlet to be used for trim-

mer/edger. You may use receptacles

with built-in GFCI protection for

this safety measure.







1. Maintain trimmer/edger with care.

•

Inspect trimmer/edger cord pe-

riodically, and if damaged, have

it repaired by a qualiﬁed service

facility.

• Inspect extension cords periodically

and replace if damaged.

• If trimmer/edger is not working

properly, has been dropped, dam-

aged, left outdoors, or dropped into

water, have it repaired by a qualiﬁed

service center.

• Keep handles dry, clean, and free

from oil and grease.

• Keep guards in place and in work-

ing order.

2. Check damaged parts.

• If a part is damaged, carefully check

the damaged part before using the

trimmer/edger. Make sure the part

will operate properly and perform

its intended function.

• Check for alignment of moving

parts, binding of moving parts,

breakage of parts, mounting, and

any other condition that may aﬀect

its operation.

• A guard or other part that is dam-

aged should be properly repaired or

replaced by a qualiﬁed service center

unless indicated elsewhere in this

manual.

• Use only geniune Remington®

replacement parts and accessories.

ese are available from your local

dealer. Use of any non-Reming-

ton® parts or accessories could lead

to injury to the user, damage to the

unit, and void you warranty.

3. Servicing of Double-Insulated

Tools:

• In a double-insulated tool, two

systems of insulation are provided

instead of grounding. No ground-

ing means is provided on a double-

insulated tool, nor should

a means

for grounding be added to the tool.

Servicing a double-insulated tool

requires extreme care and knowl-

edge of the system, and should

be done only by qualiﬁed service

personnel. Replacement parts for

a double-insulated tool must be

identical to the parts they replace.

4. Store idle trimmer/edger indoors.

When not in use, store trimmer/edger

and extension cord indoors in a dry

location. Store trimmer/edger above

the reach of children or in a locked

area out of the reach of children.

is manual is your guide to safe and proper

operation of the trimmer/edger.

SAVE THESE

INSTRUCTIONS.





1. Stay alert. Watch what you are doing.

Use common sense.

2.

Be aware of extension cord while operat-

ing trimmer/edger. Be careful not to trip

over extension cord.

3. Avoid unintentional starting. Do

not carry plugged-in trimmer/edger

with ﬁnger on switch. Be sure switch

is OFF when plugging in trimmer/

edger.

4. Do not overreach. Keep proper foot-

ing and balance at all times when

operating trimmer/edger.

5.

Disconnect the trimmer/edger from

the power supply

• when not in use

• before servicing

6. Do not force trimmer/edger. It will do

the job better and with less likelihood

of a risk of injury at the rate for which

it was designed.

7. Do not abuse power cord. Never pull

or carry trimmer/edger

by power cord.

Never yank cord to disconnect from

receptacle. Keep power cord from

heat, oil, and sharp edges.

8. Keep hands and feet away from cut-

ting area.

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

Comments to this Manuals

No comments