Remington RM112ST Owner's Manual download pdf (Page 14)

 



8. Lay the line from the left mounting

hole into the upper spool section. Lay

the line from the right mounting hole

across the other line. Insert this line

into the retaining slot between the

upper and lower spool section, then

lay the line into the lower spool sec-

tion. See Figure 4-20 for proper line

placement.

9. Place the line from the upper spool

section

through the line retaining ring

(see Figure 4-21).

10. Place the line retaining ring back on

the spool (see Figure 4-22).

11. Position each line section in the slots

on either side of the retaining ring

(see Figure 4-23).

12. Hold the retaining ring in place

and make sure the line remains in

the retaining ring slots. Rotate the

spool while holding the retain-

ing ring in place. e line will roll

onto the spool (see Figure 4-24).

IMPORTANT: Make sure to rotate the

spool so the line winds onto spool in

the direction indicated on the spool

top. Wind line until four inches of

line remains outside the spool.

13. Replace spool onto spool spring and

press spool down. Lay exposed trim-

mer/edger line into slots on spool

housing (see Figure 4-25).

14. Align tabs on spool cover with slots

in spool housing. Replace spool cover

onto spool housing and snap into

place (see Figure 4-26).

Figure 4-20: Arranging line into spool

Figure 4-21: Placing upper spool line into retaining ring

Figure 4-23: Positioning line in retaining ring slots

Figure 4-22: Placing retaining ring onto spool

Retaining

Slot

Lines Through

Slots in

Retaining Ring

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 63 64

Comments to this Manuals

No comments

Remington RM112ST Owner's Manual Page 14

Comments to this Manuals